Search the Community
Showing results for tags 'small printer'.
Found 5 results
-
Please flip it back 90° like it used to print out. I can print it out just fine when I rotate the Small Printer to the "shorter" side of the platform. I have not checked how this goes on other platforms but I wouldn't put small printer on anything bigger than Platform B -
Summary: 1.1.2.0 - Steam - Can't print Medium Platform B when Small Printer is on a platform Description: The last update changed the orientation that platforms are printed at (Longways away from the printer). The offset the Medium Platform B uses to set itself away from the edge of a platform is not large enough and you can NOT print a Medium Platform B when the small printer is on a platform itself (for most orientations)... the silhouette shows a collision. Workaround: The small printer must be placed on the ground in order to not have a collision. Platform: Steam (and likely XBox One & Windows 10 Store) Version / Build Number: 1.1.2.0 Specifications: OS: Windows 10 Pro x64 | v. 1803 | Build 17134.765 CPU: AMD Ryzen 7 1700X 3.90 GHz GPU: ASUS GeForce GTX 1070 O8GB RAM: Team T-Force DARK 16GB (2 x 8GB) DDR4 3000 (PC4 24000) Drive: Samsung 960 EVO 500GB NVMe - M.2 -
I was trying to get a semi-automatic medium storage maker using the soil centrifuge after seeing that resources could automatically fill printer slots. However when I put 4 small printers (1 in each slot) on the same platform as the soil centrifuge, it for some reason decides not to distribute the resin into the slots. I've uploaded a short video to Imgur that shows what I'm talking about. https://imgur.com/a/hYtDAdz -
Summary: The console of the small printer stays open if the small rover is entered while the console is open Description: I wanted to start printing things, but the rover was parked right next to it, so I wanted to move it, but didn't close the console of the printer. After the figure entered the rover, the console stayed open and did not cancel the printing hologram. Platform: Steam Version / Build Number: 0.9.2.0 Specifications: OS: Windows 10 Pro, 64bit, Version 1803, OS Build 17134.191 CPU: Intel Core i5-7500, 3.4 Ghz in Asrock Fatal1ty H270M GPU: ZOTAC GeForce GTX 1080 8GB RAM: Crucial 16GB Kit (8GBx2) DDR4 2400 MT/s (PC4-19200) Drive: Crucial MX300 525GB M.2 (2280) Solid State Drive
-
I have a full backpack. I had Tethers selected in the backpack printer. Then I switched to another item to print. Because my backpack was full there was nowhere for the compound in the printer slot to go. It just went spinning off into the cosmos never to be seen again. This occurred because I had the "Tethers" already selected, which pulled in a Compound resource. Then I filled my backpack by mining Resin. My suggestion would be to never have a resource actually consume a slow in the printer. Only have the printer consume the resource when print is chosen, and not pre-load itself with the resource.
